NVC in Carpentry and Joinery - NBTE

More documents

Recommendations

Info

NVC in Carpentry and Joinery (Draft) General Objective: 8.0: Carryout operations on Tenoning Machines WEEK Specific Learning Objective Teachers Activities Learning Resources Specific Learning Objective 8.1 Mount and dismantle tenoning blade on the machine Teachers Activities • Demonstrate the procedures involved Learning Resources • Tenoning Machines • Materials 8.2 Set-up and use the machine to undertake the cutting of tenons. 8.3 Under take routine service and maintenance of tenoning machines. General Objective: 9.0: Carryout operations on Vertical Spindle Molding Machine. • Guide the trainees • Observe performance Rate performance WEEK Specific Learning Objective Teachers Activities Learning Resources Specific Learning Objective 9.1 Mount and dismantle cutters on spindler molding machine. Teachers Activities • Demonstrate the procedures involved Learning Resources • Spindle Moulder • Materials 9.2 Set-up and use the spindle machine for cutting different shapes and curves e.g - Moulding - Ogee Curves - Ovolo - Bevels, Chamfers • Guide the trainees • Observe performance Rate performance 36
NVC in Carpentry and Joinery (Draft) - Molding, etc. 9.3 Undertake service and routine maintenance of the spindle molding machine. 9.4 Observe safety precautions in using the spindle molding machine. Assessment: 20% Practical: 80% 37
Page 1 and 2: NVC in Carpentry and Joinery (Draft
Page 3 and 4: 4.0 STRUCTURE OF PROGRAMME: NVC in
Page 35: NVC in Carpentry and Joinery (Draft
Page 59 and 60: General Objective: 3.0: Understand
Page 73 and 74: PROGRAMME: NVC IN CARPENTRY AND JOI

NVC in Carpentry and Joinery - NBTE

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?