download PDF - Switchover Help Scheme
download PDF - Switchover Help Scheme
download PDF - Switchover Help Scheme
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
Switching the Receiver on<br />
q<br />
w<br />
To Turn on Power to the Receiver:<br />
1. Switch on power at the wall socket, if required.<br />
2. Within a few seconds the Green q and Red w Power LEDs will light.<br />
3. After start up is complete, an image is displayed on your TV screen and the Green q Power<br />
LED will remain on.<br />
To Turn off Power to the Receiver:<br />
1. Press the [ STB] button on the remote control. The Power LED changes to Red w.<br />
2. Press the switch on the wall socket to completely turn off the power to the receiver.<br />
Standby Mode<br />
When the Red Power LED w is on the receiver is in Standby mode. You can go in/out of Standby<br />
mode by pressing the [ STB] button on the remote control.<br />
Note:<br />
• It is recommended that the receiver be left in Standby mode rather than switching off completely, in order to allow<br />
important updates to be received via your aerial or internet connection.<br />
• Whenever the receiver receives a signal from the remote control, the Power LED blinks Red.<br />
• After turning on, it takes some time before the receiver starts up. Please note that buttons on the remote control do not<br />
work during this period of time.<br />
• Do not switch the power on/off repeatedly within a short period of time. It could cause a malfunction.<br />
• If a power cut occurs when using the receiver, unplug the AC mains adaptor to avoid sudden surges of electricity when the<br />
power comes back on.<br />
12<br />
HDZ-100 User Guide.indb 12 16/04/2012 15:10