download PDF - Switchover Help Scheme

Manually Programming the Remote Control
If your TV brand is not included in the code list, or the brand codes in the list do not operate your
equipment, it may still be possible to programme the remote control to operate your equipment.
1. Press and hold the [ ] button and the [AD] button for 3 seconds, then the [ TV] button
flashes twice and lights on.
2. Aim the remote at the target TV, press the [Ch+] or [Ch–] button to enter Manual Search Mode,
the [ TV] button starts to flash. Press the [Ch+] button to search forward or [Ch–] to search
backward through the brand codes. Continuously press the [Ch+] or [Ch–] button until the
target TV set is switched off, then press the [OK] button to save the codeset and the [ TV]
button goes off.
3. Check whether the other buttons [ +/–], [ ], [TV Input] work. If they don’t, go back to steps
(2) and (3).
Finding the Remote Control’s Current Codes
If you have used the procedure above to programme the remote control to operate your TV, it may be
useful to know the correct code for your equipment.
Knowing the codes that operate your equipment will allow you to re-programme the remote control quickly using
the procedure on the previous page, should the need arise. Make a note of your code and keep it in a safe place.
1. Press and Hold the [ ] button and [GUIDE] button at the same time for 3 seconds, then the
[ TV] button flashes twice and switches off.
2. Press the [1] button and count the number of times the [ TV] button flashes. The number of
flashes is the first number of the code. No flashes indicates a zero.
3. Press the [2] button and count the number of times the [ TV] button flashes. The number of
flashes is the second number of the code. No flashes indicates a zero.
4. Press the [3] button and count the number of times the [ TV] button flashes. The number of
flashes is the third number of the code. No flashes indicates a zero.
38
HDZ-100 User Guide.indb 38 16/04/2012 15:10