KODAK EASYSHARE DX4900 Zoom Digital Camera User's Guide
KODAK EASYSHARE DX4900 Zoom Digital Camera User's Guide
KODAK EASYSHARE DX4900 Zoom Digital Camera User's Guide
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
64<br />
Chapter 9<br />
<strong>Camera</strong><br />
Problem Cause Solution<br />
Picture is too dark. Flash is not on or did not<br />
function.<br />
Turn on the flash (page 19).<br />
<strong>Camera</strong> does not<br />
turn on.<br />
<strong>Camera</strong> freezes up<br />
when a card is<br />
inserted or<br />
removed.<br />
The subject is too far<br />
away for the flash to have<br />
an effect.<br />
The subject is in front of<br />
a bright light (backlit).<br />
Battery is not properly<br />
installed.<br />
Move closer to your subject:<br />
no farther than 7.5 ft (2.3<br />
m) in Telephoto, no farther<br />
than 10.5 ft (3.2 m) in Wide<br />
Angle.<br />
Change your position so the<br />
light is not behind the<br />
subject.<br />
Remove and reinstall the<br />
batteries (page 3).<br />
Battery is not charged. Replace or recharge the<br />
batteries (page 3).<br />
<strong>Camera</strong> detects an error<br />
when the card was<br />
inserted or removed.<br />
Turn the camera off, then<br />
back on. Make sure the<br />
camera is turned off before<br />
inserting or removing a<br />
card.<br />
Picture is too light. The flash is not needed. Change to Auto flash or turn<br />
flash off (page 19).<br />
The subject is too close Move so there is at least<br />
when the flash was used. 1.6 ft (0.5 m) between the<br />
camera and the subject.<br />
The light sensor is<br />
covered.<br />
Hold the camera so your<br />
hands or other objects do<br />
not cover the light sensor.
Change language