Kalzip® Systems
Kalzip® Systems
Kalzip® Systems
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
General data and characteristics<br />
5.3 Tapered shapes<br />
Tapered Kalzip profile sheets have become<br />
increasingly significant for roofing appli ca -<br />
tions as they can be formed into a diverse<br />
range of shapes. A roof can offer more<br />
than just protection: it can enable a building<br />
to achieve architectural perfection. In<br />
order to achieve the perfect structure, it<br />
is necessary to take into account several<br />
fundamental considerations. The cover<br />
widths are between 230 and 740 mm. Furthermore,<br />
accessibility is limited.<br />
The bottom sheet must be additionally<br />
supported by rigid insulation. Load distri buting<br />
walkways must be provided. In order<br />
to ensure that the bottom sheet is adequately<br />
rigid, it is essential to incorporate<br />
an eaves angle.<br />
The full surface is always covered with foil.<br />
Anti-condensation coating is only subsequently<br />
available in the spraying process.<br />
Aquasine coating is not possible. Tapered<br />
Kalzip sheets must be installed on the roof<br />
in accordance with the installation instructions.<br />
It is advisable to compare the actual<br />
dimensions of the substructure with the<br />
dimensions stated on the installation instructions<br />
before production in the factory<br />
begins. Larger building tolerances can<br />
require repartitioning of the area which is<br />
to be covered. The tables on the following<br />
page apply to a sheet width of 500 mm.<br />
Finish:<br />
• stucco-embossed<br />
• AluPlusPatina<br />
• soated material with protection foil<br />
• AluPlusZinc with protection foil<br />
Profile types available Kalzip 65/… und 50/… Kalzip AF… Kalzip AS…<br />
Minimum construction width 230 mm 170 mm<br />
Maximum width 740 mm 1 740 mm 1<br />
Minimum length 1500 mm 1500 mm<br />
Maximum length Dependent on transport Dependent on transport<br />
not possible<br />
Plate thicknesses 0.80 – 1.20 mm 0.80 – 1.20 mm<br />
Curved and tapered<br />
Possible for construction widths of 230 – 620 mm.<br />
Only following approval from the technical department in Koblenz.<br />
1<br />
Applies only to stucco-embossed and colour-coated Kalzip profile sheets. Other material combinations are available on request.<br />
Joint carried out as a welded joint<br />
or step joint<br />
min.<br />
Self-supporting up to a<br />
construction width of 500 mm<br />
max.<br />
For construction widths exceeding 500 mm<br />
only with additional support and clips spaced<br />
at 1.0 m max.<br />
Installation examples with joints<br />
Kalzip 27