Compatible Control - HUBER

1. Safety
1.1 Intended Use
General Safety Instructions
The thermostat is designed for industrial applications.
The thermostat is used for direct and indirect thermoregulation, i.e. for
heating or cooling external substances through suitable thermal fluids.
It must be operated strictly in compliance with the operating instructions.
The thermostat must not be modified by the plant operator or any
operating personnel.
The thermostat must not be used for purposes other than thermoregulation
in compliance with the operating instructions.
Unintended use or use not in compliance with the operating instructions
may lead to severe personal injury or property damage.
Your device has been designed and constructed according to the state
of the art and in compliance with the generally accepted safety rules.
Nonetheless, your device may constitute an imminent or unexpected
hazard. For this reason, your device has been equipped with safety
devices. Deactivating these safety devices bears high risks
and invalidates the warranty.
Use the device only if it is in good order and condition.
Shut down the device immediately in the case of malfunctions or
failures.
Only qualified personnel is permitted to perform repairs.
Do not bypass, bridge, dismount or deactivate any safety devices.
The manufacturer assumes no liability for damage due to technical
modifications, improper handling or use of the device disregarding the
operating instructions.
Warning! Risk of injuries!
While operating at high temperatures, the bath lid and the housing
could become very hot. Only touch the housing and the lid by the
grips otherwise there is a risk of burns!
Never lift the bath’s lid during operation at high temperature:
- Risk of scald /burn through thermal fluid overflow.
- Risk of caustic vapours causing injuries to the respiratory tract and/
or skin!
This warning is only applicable for units with this warning sign.
Important: Transport damage!
When unpacking the device, inspect it for transport damage.
Please revert to the haulage contractor or shipping agent for settlement
of claims.
Commission a damaged device only after the damage has been
repaired or you have ascertained the full effects of damage and the
insurance agent/haulage contractor/shipping agent has given their
permission.
3