Vlado cherokee j8s.pdf - VWClub.BG

ENGINE AND PERIPHERALS
Overhauling the engine 10
Apply a thin coating of RHODORSEAL 5661 to the
supports on bearings 1 and 5 without blocking the oil
return on the sump seals.
Screw the ∅ 12 mm centering studs (G) (span 1.50) in
to the cylinder block.
Remove the shims and the studs.
Cut the side seals so that they protrude 0.5 to 0.7 mm
in relation to the sump gasket face.
Fit the bearings.
Oil the two seals.
Use two steel shims placed either side of the bearing
cap.
Lower the whole assembly.
When the bearing is almost in place, make sure that
the side seals protrude slightly over the cylinder block
on the pressure face side.
Check that the crankshaft rotates freely.
2 - Injecting with silicone.
To carry out this operation you will need:
–a 50 ml syringe
–a 5 ml tube of hardener,
– a spatula for mixing,
– a user's guide.
IMPORTANT: the mixture must be injected within
approximately 5 minutes to prevent it from curing in
the syringe.
80352S
Downloaded from www.Manualslib.com manuals search engine
10-80