pdf tender document information - CCMB

More documents

Recommendations

Info

l) Please indicate the year in which the model was introduced in the market and confirm whether the spares and consumables for the system would be available for a minimum period of 10 years. m) Pre-installation and utility requirements for installation and running the system should be clearly mentioned. n) Availability of local service support and response time for a service call during and after warranty to be specified. o) Copies of scientific papers, references wherein offered models have been used should be enclosed. p) List of users in India of the offered models along with the names, addresses, telephone numbers and e-mail ID’s to be enclosed separately. q) Demonstration of similar models as the one(s) offered to be given on request at other customer sites. r) Technical presentations on the systems offered are to be made on request from CCMB. s) Typical sample provided to be analysed on similar systems at other customer sites and given to CCMB for evaluation (on request). t) Operating Voltage: The Entire system and accessories should work on 220/230V@50Hz. Selection of the system would be based on the response to all the above important clauses apart from the proven technical specifications and features, support, service and suitability to CCMB’s requirements. Please therefore respond to all the points. All the specifications and points should be supported by the original literature/brochure. BID DOCUMENT (YC) Page 34 of 63
ITEM NO.6 - PROTEIN PURIFICATION SYSTEM, QTY: 4 NOS. (FILE REF: 34/CCMB/APP/403/P12) SPECIFICATIONS FOR PROTEIN PURIFICATION SYSTEM 1. Gradient : Binary Gradient with multiple buffer selection facility. 2. Flow range : 0.01 to 10.00 ml/min 3. Pressure range : 0- 3500 psi with programmable upper and lower limits 4. Mixing : High pressure mixing 5. Sample injection : Auto injector / Manual injector 6. Sample loops : Various sizes covering 100 ul – 5ml 7. Detection : Variable wave length UV/Vis detector, PH, Conductivity 8. Wavelength range : 190 – 700 nm 9. Conductivity range : 0-500 ms/cm 10. PH Range : 2-12 11. Fraction collector : Time, Drop and Peak fractionation modes. 12. System control : PC-based along with software for control and data acquisition 13. Cold room compatibility : Entire system along with computer should be cold room compatible. 14. Biocompatibility : System should be Biocompatible. 15. Column Cross compatibility : Required (All adopters and accessories to make the system Compatible for third party columns to be included in the offer) 16.Column and Media : Please quote separately (including the column list enclosed) 17. Power : All components including subsystems, accessories and Computers must be compatible with 220 volts, 50Hz electrical power List of Columns required by CCMB A. Preparative-grade or semi-prep Columns for gel-filtration or size exclusion chromatography: Columns with bed volume of approx. 100-150 ml and separation ranges of 1 kDa-100 kDa and 10 kDa-500 kDa (other separation range should also be provided if available) (Columns of different resins (bead size is different and thus resolution) should be included) B. Analytical-grade Gel-filtration Columns: Columns with bed volume of approx. 20-30 ml and separation ranges of 1 kDa-100 kDa and 10 kDa-500 kDa each (Columns of different resins (bead size is different) should be included) C. Cation-Exchange FPLC Columns: 1. Strong-binding resin with bed volume of approx. 20 ml 2. Weak-binding resin with bed volume of approx. 20 ml D. Anion-Exchange FPLC Columns: 1. Strong-binding resin with bed volume of approx. 20 ml 2. Weak-binding resin with bed volume of approx. 20 ml BID DOCUMENT (YC) Page 35 of 63
Page 1 and 2: CENTRE FOR CELLULAR & MOLECULAR BIO
Page 3 and 4: VERY IMPORTANT: Pre-Bid Conference
Page 5 and 6: CHAPTER - II: INSTRUCTION TO BIDDER
Page 7 and 8: 10 Documents Establishing Bidder’
Page 9 and 10: E. OPENING AND EVALUATION OF BIDS T
Page 11 and 12: CHAPTER - III: GENERAL CONDITIONS O
Page 13 and 14: 15.2This warranty shall remain vali
Page 15 and 16: CHAPTER - IV: SPECIAL CONDITIONS OF
Page 17 and 18: 17 Supplier Integrity 17.1The Suppl
Page 19 and 20: CHAPTER - VI: BID SECURITY FORM Whe
Page 21 and 22: CHAPTER - VIII: BIDDER’S PERFORMA
Page 23 and 24: CHAPTER - X: DEVIATION STATEMENT FO
Page 25 and 26: CHAPTER - XII: CONTRACT FORM THIS A
Page 27 and 28: CHAPTER XIV: QUALIFICATION REQUIREM
Page 29 and 30: ITEM NO.2 - FLUORESCENCE MICROSCOPE
Page 31 and 32: 3. Ambient temperature: 42 deg. C 4
Page 33: ITEM NO.5 - HIGH RESOLUTION FTIR SY
Page 37 and 38: ITEM NO.7 - PHOSPHOR IMAGER ALONG W
Page 39 and 40: ITEM NO.8 - UPRIGHT FLUORESCENCE MI
Page 41 and 42: ITEM NO.9 - ADVANCED MOTORIZED INVE
Page 43 and 44: ITEM NO.10 - SPECTRAL CONFOCAL MICR
Page 45 and 46: ITEM NO.11 - HIGH RESOLUTION MASS S
Page 47 and 48: ITEM NO.12 - HIGH SENSITIVITY CD SP
Page 49 and 50: 2. All the above mentioned technica
Page 51 and 52: . The computer and printer offered
Page 53 and 54: 2. Cost should include three years
Page 55 and 56: 2. Capacity : 8 x 5 ml or more Maxi
Page 57 and 58: ITEM NO.17 - ZEBRA FISH IMAGING AND
Page 59 and 60: ITEM NO.18 - HIGH CONTENT SCREENING
Page 61 and 62: 7. Software supplied should be the
Page 63: Main system including subsystems, c

pdf tender document information - CCMB

Create successful ePaper yourself

Delete template?

Save as template?