User's Manual NX-2430

Dot adjustment mode
This mode is used to adjust the vertical alignment of text and graphics on
successive bi-directional passes.
After a period of time, your printer may work itself out of alignment on left
and right printing passes, appearing most visibly during graphics printing.
This mode will probably be used very rarely.
1.
Turn the printer off and then turn it on again while holding down the
EJECT/PARK I and 1 ON LINE ] buttons. The “dA” message will show
on the display, and the printer will then print something like the
following:
* * * DOT ADJUSTMENT SETTING * * *
LQ o : ! / I I i I I I I I I I I I I i I ! I I ~I I I I I I I : I I i I I I I I I I
2.
3.
The printer will feed the paper forwards and backwards during this
operation, allowing you to view the paper for optimum alignment.
To adjust the printing, use the [ EJECT/PARK]and I PAPERFEED [buttons.
The I-EJECT/PARKI button will move the second pass to the left. The
I PAPER FEED 1 button will move the second pass to the right.
4. When the two passes are aligned with each other to form one continuous
line, the bi-directional alignment test is completed.
38