04.01.2015 Views

User's Manual NX-2430

User's Manual NX-2430

User's Manual NX-2430

SHOW MORE
SHOW LESS

Create successful ePaper yourself

Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.

INTERFACE CONVERTER (SPC-8K)<br />

To run the printer in serial mode, you should use the optional Serial/Parallel<br />

Converter (SPC-8K).<br />

The procedure to install the Converter is:<br />

1.<br />

2.<br />

3.<br />

4.<br />

5.<br />

-<br />

Setthe DIP switches on the SPC-8K before attaching itto the printer. (See<br />

next page for detailed information.)<br />

Turn off the power switch and disconnect the power cord from the power<br />

source.<br />

Disconnect the interface cable if attached.<br />

Connect the Parallel connector to the printer.<br />

Move both clips inside the extended prongs on the sides of the plug until<br />

you hear a click,<br />

1<br />

Figure 7-21. Connect the Parallel connector to the printer.<br />

6. Connect the Serial connector to your computer.<br />

NOTE: Place the Converter on a table in order not to damage the cable.<br />

[CORRECTMETHOD]<br />

[INCORRECTMETHOD]<br />

Figure 7-22. Place the converter on a table,<br />

78

Hooray! Your file is uploaded and ready to be published.

Saved successfully!

Ooh no, something went wrong!