User's Manual NX-2430

●
Printer does not feed paper
Probable Cause
Paperisjamming.
Bailleveris closed
before paper goes
throughthebaillever
location.
Adjustment lever
is set incorrectly.
Fanfold form is
parked.
Action
Remove all forms and pieces of paper.
Open the bail lever. Bail lever automatically closed when
the paper goes through the bail lever location.
Check the settingof the adjustment lever. See “Adjusting
the printing gap” in Chapter 3.
Move bail lever forward to unpark the fanfold paper.
●
Line spacing is incorrect or overprinting occurs
Probable Cause
The tractor positions
are incorrectly
adjusted.
Incorrect emulation
is selected.
Problem with the
application
program.
Platen knob was
manually turned
while the Power
indicator was on.
Forms are jamming
between
printing surface
and the print
head.
Action
Adjustthe tractorpositions. See“Loading fanfold forms”
in Chapter 3.
Select the other emulation with the EDS setting. See
Chapter 5.
Refer to your application program manual.
Set the top of form. See “Top of form” in Chapter 4.
Do not manually turn the platen knob when the power is
on. Use the I PAPERFEED [button.
Reset adjustment lever. See “Adjusting the printing gap”
in Chapter 3.
59