CFR 2014/2015
Last years release of the Mountain rack was a huge success. e response from the the low pro-le 3 3/4" height rack weighing in at a featherweight 3.8 pounds was overwhelming. Customers noticed that by dropping the center of mass, and lowering all the weight that is carried in the rack, there snowmobile performed better under load. e Mountain racks design allowing Ski Doo XM factory Holes to be used to install the rack was an added bonus as well. eabuse of rollovers and bumpy access roads were no match for the strong yet lightweight Mountain rack. A unanimous winner!
Last years release of the Mountain rack was a huge success.
e response from the the low pro-le 3 3/4" height rack
weighing in at a featherweight 3.8 pounds was overwhelming.
Customers noticed that by dropping the center of mass, and
lowering all the weight that is carried in the rack, there
snowmobile performed better under load. e Mountain racks
design allowing Ski Doo XM factory Holes to be used to install
the rack was an added bonus as well. eabuse of rollovers and
bumpy access roads were no match for the strong yet
lightweight Mountain rack. A unanimous winner!
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
Blades<br />
Ad a little more Metal to your Ski Doo<br />
XP/XM. The <strong>CFR</strong> Blades are designed to<br />
be fastened to the outside or inside of the<br />
rear tunnel of your 146”, 154", 163 or 174<br />
tunnel. The added 50% more strength<br />
allows more weight to be carried on the<br />
tunnel. The <strong>CFR</strong> Blades are<br />
recommended if you travel on bumpy<br />
roads carrying lots of extra weight on<br />
your snowmobile.<br />
Features<br />
- Anatomically designed to fit the rear tunnel of the Ski Doo XP/XM.<br />
- Comes in 146”, 154” , 163”and 174" lengths.<br />
- Mount them on the inside of your tunnel for the stock look.<br />
- Mount them on the outside for the check me out I’m awesome look.<br />
- Come complete with 1 right/1 left side.<br />
- All Rivets and mounting hardware included.<br />
Part# TS01 -146” Track length<br />
Part# TS02 -154” Track length<br />
Part# TS03 -163” Track length<br />
Part# TS07 -174” Track length.<br />
Nytro Blades square off the rear<br />
rounded tunnel leaving a flat platform<br />
to mount <strong>CFR</strong> tunnel racks.<br />
Part# TS04 2010-2013 Yamaha Nytro.<br />
Part# TS05 2008-2009 Yamaha Nytro.<br />
06-08 Arctic Cat Blades go on dimples<br />
that are on top of rear tunnel allowing<br />
a flat surface for rack to sit on.<br />
Part# TS06 2008-2009 Arctic Cat<br />
Photo: Bryn Hughes<br />
Tandemers: Dan Treadway<br />
Logan Pehota<br />
23
Change language