CFR 2014/2015
Last years release of the Mountain rack was a huge success. e response from the the low pro-le 3 3/4" height rack weighing in at a featherweight 3.8 pounds was overwhelming. Customers noticed that by dropping the center of mass, and lowering all the weight that is carried in the rack, there snowmobile performed better under load. e Mountain racks design allowing Ski Doo XM factory Holes to be used to install the rack was an added bonus as well. eabuse of rollovers and bumpy access roads were no match for the strong yet lightweight Mountain rack. A unanimous winner!
Last years release of the Mountain rack was a huge success.
e response from the the low pro-le 3 3/4" height rack
weighing in at a featherweight 3.8 pounds was overwhelming.
Customers noticed that by dropping the center of mass, and
lowering all the weight that is carried in the rack, there
snowmobile performed better under load. e Mountain racks
design allowing Ski Doo XM factory Holes to be used to install
the rack was an added bonus as well. eabuse of rollovers and
bumpy access roads were no match for the strong yet
lightweight Mountain rack. A unanimous winner!
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
Aluminium Rachet<br />
Part# 1006<br />
The <strong>CFR</strong> Aluminum Ratchet is custom made to take the<br />
abuse that snowmobiling throws at it.<br />
These custom made ratchets are designed to hold your<br />
snowboard and or skis down solid until you need them no matter what!. The powder<br />
coated black finish will keep them rust free and looking good. The thick springs are long<br />
lasting and will give you years of trouble free use.<br />
-This Ratchet will replace all <strong>CFR</strong> ratchets current and past years.<br />
Ladder Strap<br />
Spare Parts<br />
Part# 1003<br />
The <strong>CFR</strong> 220MM Replacement Ladder Strap<br />
works on all of our Snowboard and Ski Brackets.<br />
-64 Stainless Steele rivet and two washers included.<br />
Replacment Strap<br />
Part# 1001<br />
8" Replacement Strap<br />
The <strong>CFR</strong> 8” replacement strap is used in most of the snowboard<br />
and ski rack carrying racks that we manufacture. A 66 Stainless<br />
steel rivet and two washers included.<br />
Part# 1002<br />
16" Replacement Strap<br />
The <strong>CFR</strong> 16” replacement strap is used in all of the snowboard and ski rack carrying<br />
racks that we manufacture. A 64 Stainless steel rivet and washer included.<br />
24<br />
Photo: Phil Tifo<br />
Snowmobiler: Dan Treadway
Change language