CFR 2014/2015
Last years release of the Mountain rack was a huge success. e response from the the low pro-le 3 3/4" height rack weighing in at a featherweight 3.8 pounds was overwhelming. Customers noticed that by dropping the center of mass, and lowering all the weight that is carried in the rack, there snowmobile performed better under load. e Mountain racks design allowing Ski Doo XM factory Holes to be used to install the rack was an added bonus as well. eabuse of rollovers and bumpy access roads were no match for the strong yet lightweight Mountain rack. A unanimous winner!
Last years release of the Mountain rack was a huge success.
e response from the the low pro-le 3 3/4" height rack
weighing in at a featherweight 3.8 pounds was overwhelming.
Customers noticed that by dropping the center of mass, and
lowering all the weight that is carried in the rack, there
snowmobile performed better under load. e Mountain racks
design allowing Ski Doo XM factory Holes to be used to install
the rack was an added bonus as well. eabuse of rollovers and
bumpy access roads were no match for the strong yet
lightweight Mountain rack. A unanimous winner!
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
Snowboard bracket kit<br />
Part# K01<br />
The snowmobile Snowboard rack that is tested and approved by professional snowboarders<br />
Travis Rice, Mark Carter, Mark Landvik, Helen Schettini and Annie Boulanger. The <strong>CFR</strong><br />
Snowboard Bracket Kit will keep your snowboard out of the way while snowmobiling. You will<br />
forget that you have your snowboard with you breaking trail to the top of your favorite<br />
snowboard line or jump spot. This package contains parts and hardware to carry one snowboard<br />
on D, DD, i or Mountain Rack. Another Snowboard Bracket Kit can be purchased to carry up to<br />
two Snowboards.<br />
Features:<br />
-Professionally used and approved by Snowboarders Travis Rice,<br />
Mark Carter, Mark Landvik, Helen Schettini and Annie Boulanger.<br />
-Light weight Nylon parts are infused with resin that makes<br />
them extremely strong and can handle -100 degree cold temps.<br />
-Injected molded straps that can withstand down to -100 degree cold temps but will break in<br />
severe roll overs to prevent damage.<br />
-Ratchets and Ladders are custom made for superior ratcheting lockdown.<br />
-All mounting Hardware included is made from high grade stainless steel.<br />
(Super strong and rust Free)<br />
-Carries one snowboard. Another Snowboard Bracket Kit can be purchased to carry up to two<br />
snowboards.<br />
Photo: db<br />
Shredder: Brian Hockenstien<br />
5
Change language