Installation and Maintenance Guide, HiPath ProCenter Standard

misserver.fm
Installing HiPath ProCenter on a server machine
Installing HiPath ProCenter on a main server machine
Nur für den internen Gebrauch
Installation Requirement
Hicom 300 E Information
HiPath 3000/5000
Information
CAP Fault Management
Information (optional)
Dialing Properties
Information
Time Server Information
Information
ACD number: __________________
ACD group number: __________________
Route Control Group number: __________________
RSM server name ____________________
Trap destination: __________________
Note: This is the IP address or host name of the machine to
which you want to send trap notifications.
Current location: __________________
Country code: __________________
Area code: __________________
Local access code: __________________
Note: This information is required to use the assisted dialing
feature in the Client Desktop application.
Time server name: __________________
Table 4-1
Installation worksheet
Note: This information is only required if the time service is not
already configured.
4.1.2 Installing HiPath ProCenter on a main server machine
Follow the instructions in this section to install the HiPath ProCenter server software on a main
server machine.
installing HiPath ProCenter server software on a main server machine,
ensure that you have properly configured the IP address of the server machine.
Before
To install HiPath ProCenter software on a main server machine:
7
1. Log on to the computer as an Administrator. Only users with administrative rights can
install HiPath ProCenter software.
2. Insert the HiPath ProCenter 6.5 CD1 into the CD-ROM drive.
3. On the Start menu, click Run, then type:
x:\HiPath ProCenter Server\setup.exe
where x is the CD-ROM drive letter, and then click OK.
A31003-S2265-S110-1-7620, May 2005
4-2 HiPath ProCenter Standard, Version 6.5 Installation and Maintenance Guide