B-SA4T Series - Toshiba Tec Italia

(19) Ribbon near end detection (RBN NEAR END)
• OFF: A ribbon near end state is not detected.
• 30 m: A ribbon near end state is detected when the remaining ribbon length is
approximately 30 m.
• 70 m: A ribbon near end state is detected when the remaining ribbon length is
approximately 70 m.
(20) Expansion I/O operation mode (EX. I/O)
• TYPE1: Standard mode
• TYPE2: In-line mode
(21) Plug-and-play operation (PLUG & PLAY)
• ON: A plug-and-play operation is performed.
• OFF: A plug-and-play operation is performed.
(22) Label end/ribbon error process (LBL/RBN END)
• TYPE1: When a label end or ribbon error state is detected, the printer stops even if it is
printing.
• TYPE2: When a label end or ribbon error state is detected, the printer prints the current
label as far as possible, then stops.
(23) Pre-strip process (PRE PEEL OFF)
• OFF: A pre-strip operation is not performed.
• ON: A pre-strip operation is performed.
NOTE: When the pre-strip operation parameter is set to ON, a 6-mm forward feed is
performed, then a 6-mm reverse feed before printing on the label starts. The
amount of feed can be finely adjusted.
(24) Reverse feed speed (BACK SPEED)
• STD: 3 ips
• LOW: 2 ips
(25) MaxiCode specification (MAXI CODE)
• TYPE1: Compatible with a current version
• TYPE2: Special specification
(26) Keyboard I/F (KB I/F)
• OFF: (Disabled)
• KB60(1): KB-60 Old version
• KB60(2): KB-60 Current version
• KB80: KB-80
(27) Strip motor torque (PEEL OFF TRQ)
• R0: Low
• R1: ↑
• R2: ↓
• R3: High
(28) Print head applied current table setting (TONE TABLE)
• TYPE1: Standard table
• TYPE2: Additional table 1
(29) High speed cut issue (CUT MODE)
• TYPE1: Normal cut issue
• TYPE2: High speed cut issue
(30) Multiple-label set issue (MULTI LABEL)
• OFF: Disabled (Normal operation)
• ON: Enabled (Multiple-label set issue)
(31) System mode password setting (PASSWORD)
• OFF: Password is not asked to enter the system mode.
• ON: Password is asked to enter the system mode.
- 15 -