B-SA4T Series - Toshiba Tec Italia

Print conditions:
• Print width: Approximately 100 mm
• Sensor:
Not used
• Print speed: 4 ips
• A currently selected print mode (thermal transfer/direct thermal) is used.
• Data of 16 bytes is printed on one line.
• Data is printed, starting from new data to old data.
• Data pointed by a receive buffer write pointer is printed in bold type.
Size of receive buffer
RS-232C:
Centronics:
Network I/F:
BASIC1:
BASIC2:
USB:
RFID:
1 MB (Max. 65536 lines)
1 MB (Max. 65536 lines)
1 MB (Max. 65536 lines)
8 KB (Max. 512 lines)
8 KB (Max. 512 lines)
1 MB (Max. 65536 lines)
8 KB (Max. 512 lines)
NOTES:
1. To print all data in a receive buffer, the following label length is required.
RS-232C:
Centronics:
Network I/F:
BASIC1:
BASIC2:
USB:
RFID:
198.2 m
198.2 m
198.2 m
2 m
2 m
198.2 m
2 m
2. If an error occurs during printing in receive buffer dump mode, the printer displays an
error message, then stops. The error is cleared by pressing the [PAUSE] key, and the
display is returned to the receive buffer dumping menu “ DUMP MODE”. After the
error is cleared, data is not automatically reprinted.
5.10 BASIC EXPANSION MODE
It is possible to execute the BASIC expansion mode program in BASIC expansion mode under the
following conditions:
- The BASIC expansion mode program has already been loaded.
- The BASIC enable setting mode is selected.
The basic expansion mode ends when the basic expansion program is exited.
- 23 -