Sigma Spectrum Infusion Pump User Manual

SETUP AND OPERATIONKeys- SOFT KEYS (the top row of keys on the keypad) are non-labeled keys with variousfunctions depending on what is displayed above them.- ARROWS advance cursors and select alternate choices.- HELP selects photo instructions for things such as door opening / set loading.- OK confirms entries and advances cursors.- SETUP starts programming.- LETTERS are selected by pushing corresponding numerical keys once, twice orthree times quickly.- BASIC allows selection of mL/hr setup (bypassing the Drug Error Prevention system).From BASIC, dose rate modes and ramp/taper modes may also be selected.- CLEAR erases the highlighted entry.- CLR ALL erases the entire pump set up screen.- SILENCE quiets the audio alarm for 2 minutes. Additionally, any key can be pushedfor silence.- HOLD places the pump in standby mode.- ON/OFF turns the pump on or off.- RUN/STOP starts and stops the infusion.- OPTIONS allow the user to select additional pump features.- BACK allows the user to go back.- RESET resets Manual Programming Mode to Step 1.- RAMP allows access to the Manual Programming Mode.- CLR STEP clears one step of Manual Programming Mode.- TITRATE allows flow rate changes without stopping the pump.- BOLUS allows Bolus Setup without stopping the pump.- REVIEW pulls up the set up screen without stopping the pump.Pre-Pump Programming- MOUNT THE PUMP to an IV pole.- Plug the pump into a wall outlet if available.- 13 -