10.07.2015 Views

Sigma Spectrum Infusion Pump User Manual

Sigma Spectrum Infusion Pump User Manual

Sigma Spectrum Infusion Pump User Manual

SHOW MORE
SHOW LESS

Create successful ePaper yourself

Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.

original shipping container.- Storage at elevated temperatures will diminish battery life.- Do not store in temperatures above 120°F or below -4°F and humidity should notexceed 90% RH non-condensing.Battery DisposalThe SIGMA <strong>Spectrum</strong> contains a Lithium-Ion rechargeable standardbattery pack/Wireless Battery Module. It should not be disposed of intrash or in fire. It is a recyclable product and should be disposed ofproperly. Return to SIGMA for disposal if an authorized disposal centercannot be found.CAUTIONDo not short circuit the battery terminals.Do not disassemble or modify.Battery ChargingWhen the SIGMA <strong>Spectrum</strong> is connected to the AC Power Adaptor and the adaptor isplugged into a powered outlet receptacle (mains), the pump’s standard battery pack orWireless Battery Module will be charged to full capacity. It is not necessary to turn thepump on. Charging will take approximately 8 hours for Standard Battery and 12 hoursfor the Wireless Battery Module to fully charge a depleted battery.Refer to Appendix C for a listing of the symbols used and their descriptionBattery Removal and ReplacementShould removal of the battery become necessary for any reason, the followingprocedure may be used.1. Turn unit OFF if ON.2. Disconnect the AC Power Adaptor, and lay the SIGMA Model <strong>Spectrum</strong> <strong>Pump</strong> onits front. Use a protective surface, such as plastic foam, to prevent damage tothe keypad window.3. Remove the screw located in the upper right hand corner of the SIGMA<strong>Spectrum</strong> Battery (if equipped).4. Depress the release mechanism found in the top center portion of the battery andpull away from the back of the unit.5. Install the battery by placing the battery insulation tab over the terminals and thengently sliding the battery down the back of the case and inserting the bottom ofthe battery into the pocket then pivoting it into the latch. Make sure the latch isengaged to retain the battery. Remove the battery insulating tab prior to chargingthe pump’s battery or operating the pump. Install the retaining screw (ifequipped).6. Plug the AC power adaptor into an outlet and charge for 8 hours for StandardBattery and 12 hours for the Wireless Battery Module to assure a full charge.- 29 -

Hooray! Your file is uploaded and ready to be published.

Saved successfully!

Ooh no, something went wrong!