Sigma Spectrum Infusion Pump User Manual

• Operating temperature: 60 to 80°F (15.6 to 26.7° C), 20 to 90% relative humiditynon-condensing• Storage temperature: -4 to 120°F (-20 to 49°C), 10 to 90% relative humidity noncondensingDisplay• Full color, HRTFT, 240 x 270, LED front-lit, 0.2235 mm by 0.2235 mm dot pitchAlarms and Alerts• Air-In-Line: dual beam ultrasonic detector alarms for large bubbles but allowssmaller bubbles to pass. Detects air bubbles > 1” (≈ 125µL Hospira, ≈ 140µLBaxter), will alarm if > 1 mL* of air in 15 min., < 50µL bubbles are omitted in thesummation of the 1 mL.**up to 1.5mL at 60°F• Audio: speaker actuated audio alarm, low, medium and high levels selectedthrough the configurations screen• Battery Missing – pump does not detect battery attached• Depleted Battery: pump stops running, alarms for 3 minutes• Dose Rate Limit Exceeded: the pump will run with a soft dose rate exceededafter a double confirmation, it will not run with a hard dose rate exceeded, ratesmust be reset within hard limits• Downstream Occlusion: automatic restart occurs after the downstream occlusionis cleared. Actuation can be set to Low, 6 ± 4 PSI, Medium, 13 ± 6 PSI or High,19 ±9 PSI• Inactivity: actuates after the pump has been inactive for 2 minutes• Infusion Complete: occurs when the VTBI reaches zero, at which time a KVOrate begins (The previous running rate or 1 mL/hr, whichever is lower)• In Stop – Load Set• In Stop – Open Slide Clamp• In Stop – Push Run• Low Battery - < 30 minutes of battery power remain• Shut Door• Slide Clamp Closed – Pump Stopped• System Error• Upstream Occlusion• Very Low Battery -