Download - Eurotherm Ltda

InstallationiTools2.5. TO INSTALL ITOOLS SOFTWARENote:If you are installing iTools and already have a version of iTools on your system, it isbest to ‘uninstall’ the older version rather than just writing over it. To do so selectSettings from the Windows Start Bar. Click Control Panel and double click onAdd/Remove Programs. Select iTools and click Add/Remove. Confirm thedeletion by clicking Yes when prompted. Then click OK through two consecutivedialog boxes. The existing version of iTools is uninstalled, and you are ready toinstall this version.Installation of a new version of iTools should not affect clone files which have alreadybeen produced. Clone file simulations, however, which are supplied as part of theupgrade will be overwritten. It is, therefore, advisable to make a backup of all clonefiles prior to installation of a new version of iTools.It is also recommended that all other Windows programs are closed down duringinstallation.The iTools package consists of a set of 3.5 inch disks.• Insert the disc labelled disc 1 into the diskette drive of the PC, - this will usually be drivea.• From the Windows Start Bar, click Run• Type a:\SETUPThe set up program prompts you through the installation process.Follow the instructions on the screen.The drive on which iTools will normally be installed is drive C: but an alternative drive maybe chosen.The directory where iTools will normally be installed is \Program Files\Eurotherm\iTools.Other locations are allowed and may be chosen using usual Windows methods.Note: Any version of iTools already installed in this directory will be overwritten unless adifferent directory is specified.2.6. COMMS PORTSiTools will support up to eight comms ports. During installation you will have been asked tospecify which comms ports your instruments will be connected to. ITools automaticallyscans for instruments connected to these ports (see paragraph 3.4 ‘Autodetection’ )2-4 User Handbook. Part No HA026179 Issue 2.0 Oct-99