Download - Eurotherm Ltda

Quick Tour 1iTools3.8. STORING PARAMETERS IN RECIPEA particular process may be required to run a range of products which require differentsettings to be entered into the control system. If these are held in a series of recipes a rapidand accurate way of setting up the process can be achieved.A recipe, therefore, is a customised set of parameters which can be given different valueswhich are stored in data sets. It can be named - say, with the reference of the batch to whichit applies, and downloaded into the control system.This section describes how to configure, store, and download recipes into the controllers.3.8.1. To Open the Watch/Recipe Window1. From the View menu select Watch/Recipe2. A Watch/Recipe window is displayed, see Figure 3-73.8.2. To Build a RecipeFigure 3-7: The Watch/Recipe WindowParameters of your choice may be placed into the recipe window in four ways, as follows:1. From the Device Browser, locate the required parameter from the file structure asdescribed in section 3.5.4a) Drag and drop the parameter into the Recipe windowb) Repeat the above for all required parameters2. From the menu bar of the ‘Watch/Recipe’ window click ‘Browser for parameterto add to recipe’.a) From the small browser window select the parameter and either double click theparameter or click OK3. From the main menu bar click ‘Watch/Recipe’a) Click ‘Add Parameter’b) From the small browser window select the parameter and either double click theparameter or click OK4. Right click in the Watch/Recipe window and click ‘Add Parameter’3-12 User Handbook. Part No HA026179 Issue 2.0 Oct-99