Download - Eurotherm Ltda

Quick Tour 1iTools3.5. INSTRUMENT PARAMETERSInstrument parameters are settings in the instrument which you can change to suit the process.In 2200 and 2400 instruments they are grouped under List Headings according to thefunction they perform. The List Headings are the names of sub-folders found in the DeviceBrowser.3.5.1. To Display Instrument ParametersInstrument parameters may be displayed in three ways:1. Double click on the required instrument view (or the instrument name in the DeviceBrowser)2. Right click on the instrument view (or the instrument name in the Device Browser) andselect Parameter List from the pop up window3. Left click on the required instrument view. From the Toolbar click Device Views followed by Parameter ListA list of parameters are displayed which are grouped under a List Heading. This heading isdisplayed in the upper left corner of the ‘parameters’ window, see Figure 3-3.Figure 3-3: Parameter List Heading3.5.2. To Select a Different List of Parameters1. In the Parameter List window, click on the folder . This opens a small browserwindow.The browser contains a number of folders, such as:• Operator• Programmer• Access Edit Mode• Config• Register• RIPThe names and number of folders is dependant onthe particular instrument type. This list applies to2400 seriesEach of these folders contain sub-folders. The lists of parameters are found in each ofthese sub-folders. A full list of parameters is given in the relevant instrument handbook.See Appendix C ‘List of Related Instrument Handbooks’..2. Open the required folder by double clicking on the folder (or folder name), or clickagainst the folder.3. Open the required sub-folder by double clicking on the folder (or folder name), or clickOK.3-6 User Handbook. Part No HA026179 Issue 2.0 Oct-99