Pool & Spa Heaters

PART TWO - INSTALLATION/SERVICE INSTRUCTIONSECTION 1 / RECEIVING EQUIPMENTWARNING: This appliance must be installed and serviced by a CORGI registered installer.On receipt of your equipment it is suggested that you visually check for external damage to the carton. If thecarton is damaged, a note should be made on the delivery note when signing for equipment. Remove theheater from the carton and if it is damaged, report the damage to the carrier immediately. Save the carton.These items are shipped loose inside the carton:In the 055 & 105 heaters:1. CPVC Adaptors (2)2. Plastic Gaspipe Flange (1)In the 155 heater:1. In/Out Flanges (2)2. 1-1/2" Flange Gaskets (2)3. 2" Flange Gaskets (2)4. Flange Bolts (4)5. 2" CPVC Adapters (2)In the 185, 265 and 405 heaters:1. Demountable adapters (2)2. O Rings (2)Be sure that you receive the number of packages indicated on the delivery note.When ordering parts, you must specify model and serial number of heater. When ordering under warrantyconditions, you must also specify date of installation.It is recommended that this manual be reviewed thoroughly before installing your pool/spa heater. If thereare any questions that this manual does not answer, please contact the supplier.All heaters are inter-changeable and can be used either indoor or outdoors. The appropriate top designatedfor that type of use is required. If desired, the top can be changed at a later date to change from outdoor toindoor or vice versa.CAUTION: It is perfectly normal during the first hours of operation for the ceramic boards in the combustionchamber to give off unpleasant odours. This clears permanently after three or four hours.Ensure the heater is properly and adequately ventilated during this period.730-09-04