Pool & Spa Heaters

185 265 and 405 ModelsOn/OffSwitchThermostatKnobPool Filter Blocked - YellowOn - If the pump is running and there is insufficientpressure, possibly due to a blocked Pool Filter. TheHeater will not run.Overheat - RedOn - This indicates the Heater has overheated andshutdown. Reset. If this persists this should beinvestigated by a Service Engineer.Overheat Reset (not on front panel)If the Overheat Indicator has lit the Heater will notwork until the thermostat has been reset. Wait untilthe Heater is cool then remove the door and locatethe Overheat Thermostat mounted on its bracket.Press its centre and it will click.The Red Overheat indicator will go out and theHeater can now run.055, 105 & 155 ModelsSummary of Controls (Left to Right)ON/OFF Switch - Turns the Heater On and Off andresets the Ignition Control if locked out.Lock/Unlock Button - If it is pressed for 2seconds it locks the Set Temperature so the PoolTemperature Knob is inoperative. To unlock, pressagain for 2 seconds.With a short press the Set temperature is displayed.It will flash if the Lock is ON.Pool Temperature Display - This normally showsthe Pool Temperature but also show the SettingTemperature when the Pool Temperature ControlKnob is moved. A Setting Dot is displayed whilst it isadjusted. The Display is also used for commissioningand diagnostic purposes.(Page 34)Pool Demand LED - GreenOff - There is no Pool Heating demand, pool heatingis off.On - There is Pool Heating Demand and the Pool isnot up to temperature.Flashing - The Pool Heating Demand is met, thepool is up to temperature.Pool Temperature Control Knob16°C to 32°C or 41°C (60°F to 90°F or 106°F)(Maximum is changed in Setup Mode, see Page 34)Rotate clockwise to increase the Pool Temperature.The Setting Temperature is shown whilst rotatingand for 3 seconds after.To lock the required Temperature Setting seeLock/Unlock Button.The pool or spa water temperature is controlled by thepool heater thermostat on the front panel of the heater.The control centre contains an On/Off switch and oneTemperature Control Knob. The switch functions as ameans for turning the heater on or off, however forlonger periods of isolation the Heater should beswitched off at its Mains supply.The Thermostat is fitted with a means of limiting theupper temperature limit below the maximum level.The knob stop adjustment ring illustrated below isadjustable by loosening the set screw, rotating theknobstop ring to the desired location and retighteningthe set screw.25SpaTemperatureRangekstop.tifKnobstop RingAll ModelsPRESSURE SWITCHSet ScrewPool TemperatureRangeStandbyTemperatureThe pressure switch, or heater actuator, ensures thatthe heater operates only when the filter pump is inoperation.It is factory set at 0.12 bar (1.75 PSI) for deck levelinstallations. When the heater is located below thelevel of the spa or pool, it may be necessary to resetthe pressure switch to compensate for the no-flowstatic head.If it is necessary to reset the pressure switch, werecommend the following procedure:27-01-04