Pool & Spa Heaters

INDOOR HEATERThe design is also certified by Advantica for indoorinstallation when fitted with the appropriate draughtdiverter and a suitable flue system to outside. Notethat the heater must be in a room separated fromliving rooms and provided with appropriate ventilationdirect to the outside.055 ModelsFLUE TERMINAL (Indoor) Draught DiverterIllustrationLocate and assemble as shown. Secure with screwssupplied in envelope inside carton.MountingScrewsDraughtDiverter185, 265 & 405 ModelsFLUE TERMINAL (Indoor) Draught DiverterIllustration1. Remove the louvred jacket top by removingfour (4) No.10 flat head screws.2. If originally installed, remove "Pagoda" topfrom the louvered jacket top.3. Place the inner stack adapter panel over theflue collector inside the heater. Make surethe flanged side of the flue opening is up.4. Turn the stack (diverter) upside down and set itdown bottom side up.5. Turn the jacket top panel (removed in step 1)down and place it through the stack.6. Attach the three (3) mounting brackets to thestack using the screws provided and the holesthat are pre-drilled in the stack.brackets are positioned with theMakeflangesurenearthethe top side of the stack (see illustrationbelow).Caution must be taken not to over tighten andstrip the screw threads.7. Turn the assembled stack and jacket top, rightside up. The jacket top will be trappedbetween the brackets and the top of the stack.Place the stack over the inner adapter panelflanged hole and lower the louvered jacket toppanel back into its original position. Reinstall thefour (4) No.10 flat head screws removed instep 1 above.055expl2.tif105 & 155 ModelsFLUE TERMINAL (Indoor) Draught DiverterIllustrationLocate and assemble as shown. Secure with screwssupplied in envelope inside carton.DraughtDiverterJacketTopMountingScrews (8)Screw HoleLocation3.25"82.5mmDraughtDiverterJacket Top Panel(Part of Heater)No.10 Screw (3)Mounting Bracket (3)Inner StackAdapter PanelFlue Collector(Part of Heater)term.tifS896011405term.tif01-10-98