XDT Manual - Pioneer Air Systems Engineering

XDT User’s Manualpower applied to it (the data can be changed with out limit)regenerative dryer purge . . . . small flow of dry air from drying column passing through regeneratingcolumn and desorbing water from desiccant at low pressureresponse time . . . . . . . . . . . . time it takes for a sensor to react to change in its environmentRG58. . . . . . . . . . . . . . . . . . . a type of coaxial cable - the letters/numbers refer to the electricalcharacteristic of the cable (resistance/capacitance per foot oflength)RG6. . . . . . . . . . . . . . . . . . . . A type of coaxial cable - the letters/numbers refer to the electricalcharacteristic of the cable (resistance/capacitance per foot oflength)RS-232C . . . . . . . . . . . . . . . . a specification for electrical signaling (also referred to as RS232)that describes the voltages, rate of change of the voltages, and thesignal names and uses for the signalsRTS . . . . . . . . . . . . . . . . . . . . Request To Send - a label for a RS232 interface control linesample system . . . . . . . . . . . . equipment used to bring conditioned sample to the sensing element;it may include regulators, filters, heaters/coolers, flow meters,valves and other accessories.saturate . . . . . . . . . . . . . . . . . reaching maximum holding capacitysintered . . . . . . . . . . . . . . . . . produced by a process of compacting and heating metal powder,resulting in the formation of a solid, permeable object.slip stream . . . . . . . . . . . . . . . partial stream extracted from a process stream, of which it is representativeSpanCheck . . . . . . . . . . . . method to check the response of an HTF sensor at the upper endof its measurement rangestability . . . . . . . . . . . . . . . . . a measurement's degree of insensitivity to disturbances.UL . . . . . . . . . . . . . . . . . . . . . Underwriters Laboratories Inc., an organization which evaluates,tests and certifies products for specific safety situations.uncertainty . . . . . . . . . . . . . . quantification of the error that can be expected from a measurement,characterizing the range in which the true value can beexpected to be in.36