26.11.2012 Views

IronPort - CLI reference guide

IronPort - CLI reference guide

IronPort - CLI reference guide

SHOW MORE
SHOW LESS

Create successful ePaper yourself

Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.

DRAFT - 78449 BUG FIX ONLY - CISCO CONFIDENTIAL<br />

CHAPTER<br />

Cisco <strong>IronPort</strong> AsyncOS 7.6 <strong>CLI</strong> Reference Guide<br />

2<br />

Command Line Interface: The Basics<br />

This chapter contains the following sections:<br />

Command Line Interface (<strong>CLI</strong>), page 2-1<br />

Batch Commands, page 2-9<br />

Command Line Interface (<strong>CLI</strong>)<br />

The <strong>IronPort</strong> AsyncOS Command Line Interface is an interactive interface<br />

designed to allow you to configure and monitor the <strong>IronPort</strong> appliance. The<br />

commands are invoked by entering the command name, or in the case of batch<br />

format commands the command name with arguments (or parameters). If you<br />

enter the command without arguments, the command prompts you for the required<br />

information.<br />

The Command Line Interface is accessible via SSH or Telnet on IP interfaces that<br />

have been configured with these services enabled, or via terminal emulation<br />

software on the serial port. By factory default, SSH and Telnet are configured on<br />

the Management port. Use the interfaceconfig command described in “Other<br />

Tasks in the GUI” in the Cisco <strong>IronPort</strong> AsyncOS Daily Management Guide to<br />

disable these services.<br />

1

Hooray! Your file is uploaded and ready to be published.

Saved successfully!

Ooh no, something went wrong!