26.11.2012 Views

IronPort - CLI reference guide

IronPort - CLI reference guide

IronPort - CLI reference guide

SHOW MORE
SHOW LESS

Create successful ePaper yourself

Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.

Example<br />

468<br />

Cisco <strong>IronPort</strong> AsyncOS 7.6 <strong>CLI</strong> Reference Guide<br />

Chapter<br />

Cluster Management: This command can be used in all three machine modes<br />

(cluster, group, machine).<br />

Batch Command: This command does not support a batch format.<br />

In the following example, the snmpconfig command is used to enable SNMP on<br />

the “PublicNet” interface on port 161. A passphrase for version 3 is entered and<br />

then re-entered for confirmation. The system is configured to service version 1<br />

and 2 requests, and the community string public is entered for GET requests from<br />

those versions 1 and 2. The trap target of snmp-monitor.example.com is entered.<br />

Finally, system location and contact information is entered.<br />

Table 3-154 snmpconfig<br />

mail3.example.com> snmpconfig<br />

Current SNMP settings:<br />

SNMP Disabled.<br />

Choose the operation you want to perform:<br />

- SETUP - Configure SNMP.<br />

[]> setup<br />

Do you want to enable SNMP? [N]> y<br />

Please choose an IP interface for SNMP requests.<br />

1. Data 1 (192.168.1.1/24: buttercup.run)<br />

2. Data 2 (192.168.2.1/24: buttercup.run)

Hooray! Your file is uploaded and ready to be published.

Saved successfully!

Ooh no, something went wrong!