2 - Big Ass Fans

8’–24’ POWERFOIL ® X2.0 WASHDOWN & POWERFOIL ® X2.0PLUS WASHDOWNInstallation ChecklistDo you have the appropriate mount to accommodate your roof pitch? If you are uncertain orfeel you have the incorrect mount for your building structure, please contact Customer Service at1-877-BIG-FANS.Did a structural engineer approve the mounting structure? See page 9 for Big Ass Fans-approvedmounting structures.Are you familiar with the function and use of the safety cable? See page 19 for information onproperly securing the safety cable.Will the fan be installed so that the airfoils have at least 2 ft (0.61 m) of clearance fromobstructions?Will the fan be installed so that it is not subjected to high winds such as from an HVAC systemor near a large garage door? If the fan is mounted at the same level or higher than a diffuser, thewinglets must be at a distance that is at least 1x the measure of the fan’s diameter. If the fan is mountedat the same height or below a diffuser, the winglets must be at a distance that is at least 2x the measureof the fan’s diameter.Will the distance between multiple fans be at least 2.5x the fans’ diameter when measured fromthe centers of the fans.If installing the fan on an I-beam, ensure the upper yoke is the correct size. See page 12 for moreinformation on installing the fan to an I-beam.If you ordered multiple fans, did you keep the parts for each fan together? It is critical that the airfoilsbe properly matched with the motor unit.Do you have the correct power circuit for the fan controller? See pages 2–3 for informationconcerning power requirements for the fan controller.Customer Service: 1-877-BIG-FANS(International: 1-859-233-1271)WWW.BIGASSFANS.COM ©2012 DELTA T CORP. DBA BIG ASS FAN CO. ALL RIGHTS RESERVED