2 - Big Ass Fans

8’–24’ POWERFOIL ® X2.0 WASHDOWN & POWERFOIL ® X2.0PLUS WASHDOWNElectrical Installation (cont.)Mounting the variable frequency drive (VFD)The VFD enclosure does not provide conduit knockouts. Big Ass Fans recommends using a hole punch to create conduit knockouts inthe most accessible locations on the enclosure.1. Select a mounting locationSelect a mounting location that is shaded from direct sunlight and allows enough clearance for the door to fully open. The mountingequipment.2. Predrill the VFD enclosureDrill appropriately sized holes in the VFD enclosure to accommodate the conduit connectors.Position the holes where the conduit can most accessibly exit the enclosure. Note: Useappropriately rated connectors (IP56) to protect against foreign matter from entering theenclosure.3. Mount the VFD enclosure (to the wall)Mount the VFD enclosure to the wall using the screws provided with the enclosure.Refer to the wiring diagrams on the following pages for your fan controller. Note: Wiring is not shown in the illustration below.WWW.BIGASSFANS.COM ©2012 DELTA T CORP. DBA BIG ASS FAN CO. ALL RIGHTS RESERVED