Cessna 150 Aerobat 250 ARF - Great Hobbies

18. Fit the wheel pant over the wheel and itscomponents. Make sure the wheel pant is positionedbetween the gear and the washer that was installed inStep 12. You may need to reposition the 2mm nut tofit the wheel pant into position.20. Repeat steps 14 through 19 to install theremaining main wheel and wheel pant.22. Use a wheel collar and setscrew to secure thenose wheel in position. The round side of the collarwill be against the wheel. Use a 1.5mm hex wrenchto tighten the setscrew in the wheel collar. Makesure the nose wheel can rotate freely.Always use threadlock on metal-to-metal fastenersto prevent them from vibrating loose.21. Slide the nose wheel pant on the nose gearaxle. A plywood spacer and the nose wheel arethen slid onto the nose gear axle.23. Use canopy glue to glue the nose gear wire intothe recess of the wheel pant. Use low-tack tape tohold the wheel pant in position while the glue cures.Allow the glue to fully cure before proceeding. 19. Use a #1 Phillips screwdriver to tighten themachine screw wile holding the 2mm nut usinghemostats. Make sure the landing gear is sittingin the recess of the wheel pant. Once the screwhas been tightened, use a 1.5mm hex wrench toposition the wheel collar so the wheel can rotatewithout any binding.Always use threadlock on metal-to-metal fastenersto prevent them from vibrating loose.E-flite Cessna 150 Aerobat 250 ARF Assembly Manual13