2.2 The IBM 7171 ASCII Device Attachment Control Unit - Index of

B.lO.4 Local Reset and Control FunctionsThere are six key sequences that are completely processed within the IBM 7171,and are not passed to the host. These sequences provide a way of controlling andclearing the data transmission to and from the terminal:CTRL and gCTRL and rCTRL and tCTRL and xCTRL and sCTRL and qMaster ResetCharacter Error ResetKeyboard UnlockType-ahead PurgePacing StartPacing stopB.lO.5 Installation HintsUse the EIA RS-232-C Interface in full duplex mode. There should be 7 data bits,1 stop bit and 1 parity bit testing on even parity (See Note).To set the proper baud rate there are two 16-position reels located on the rear sideof the ADM-31.Select one of the following baud rates for "Modem" and "Printer":ReelPos. No. 2 3 4 BAUD RATE5 1 0 1 0 3006 0 1 1 0 6007 1 1 1 0 120010 0 1 0 1 240012 0 0 1 1 480014 0 1 1 1 9600Note: Line speed and parity selection must conform with the specifications definedin the IBM 7171 Ports Area of memory for the appropriate communication line.Refer to section 4.4.2, "Ports Area Layout" on page 4-21.For further configuration control switch setting see the manufacturer-suppliedUser's Reference Manual.B-28 IBM 7171 Reference Manual and Programming Guide