2.2 The IBM 7171 ASCII Device Attachment Control Unit - Index of

INVALID BAUD RATE7171 TERM This error message appears when a baud rate is entered which isnot one of the allowable values. The valid baud rates are listed on the Configure7171 Ports screen.INV ALID TERMTYPE: xxxxxxxxIBM 7171 TERM This error message appears when the terminal namexxxxxxxx is not found in the TERMTYPS list in the Image file which wasloaded. Refer to the Link output listing for the list of valid terminal types.NO TERMINAL NAMES IN IMAGE7171PORT This error message appears when a file is either not an Image file(wrong file loaded) or is the output of a bad link. If this is output from aTML Link, there is no TERMTYPS statement in the TML source.NO TERMTYPS FOUND - IS YOUR CONTROL FILE EMPTY? *7171LINK This error message (not a prompt) appears when there are noterminal tables specified in the input control file. Re-edit the control file andthen relink.ONE OR MORE PARAMETERS NOT SPECIFIED7171 & 7171 TML This error message appears when there is an error loadingthe 717110 or 7171MLNK sub utilities. The user did not specify one ormore required parameters. Return to the screen and input ALL requiredparameters.RESET CHAR MUST BE AN ASCII CTRL CHAR7171 TERM This communications error message appears when the valuespecified is not a valid Reset character. All Reset characters must be ASCIIcontrol characters (OO-IF). Redefine the invalid Reset character.TOO MANY TERMTYPS, MAX = on *7171LINK This error message appears in the output listing when the7171LINK TERMTYPS table overflows: Relink using fewer terminals inthe input . CTL file.xxxxxxxx DUPLICATE TERMINAL NAME LINKED - non-fatal error, processingcontinues7171LINK This error message appears in the output listing when a terminaltable has the same terminal name as a previously linked table. The outputimage MAY be partially usable, but ·only the first terminal table will beaccessible (the duplicate(s) will not be accessible).c-76 IBM 7171 Reference Manual and Programming Guide