Call Control Curriculum Path - Genband

C2011 C20 - Solution OverviewCourse Description:This course provides a detailed introduction to the network concepts and a foundation ofknowledge required by those who are planning to support a Nortel Packet Trunking-IPnetwork. In the course, you will learn about the hardware layout, network interconnect anduser interfaces for the following CVoIP components: Ethernet Routing Switch 8600, ServicesApplication Module 21, Gateway Controller, Communication Servers, Core and BillingManager, C20Core Manager, Interworking Spectrum Peripheral Module IP, UniversalSignaling Point, Media Server 2010, Audio Provisioning Server, Media Gateway15000 andIntegrated Element Management System. This course also includes a conceptualdemonstration of a call flow and an introduction to the PT-IP network VLANs. You will learnhow to view the key datafill that enables call control messages, bearer traffic and OAM&Pmessages that can be routed in a PT-IP network.Intended Audience:Anyone planning to support a Nortel Packet Trunking-IP solutionKey Topics:Overviews of:Network topographyNetwork component identification and hardware basicsComponent connectivityUser interfacesCall flow: ISUP on MG15000 to ISUP on MG15000CallP VLANSignaling and bearer paths to support ISUP on MG15000OAM&P VLANOAM&P pathsObjectives:At the end of the course the students will be able to:Describe the purpose, hardware, and connectivity of each network component in thePT-IP network.Demonstrate access to and basic navigation of the user interfaces.Describe the progression of a sample call flow through the PT-IP network.Identify the hardware and key IP provisioning that enables call control messages andbearer traffic to be routed between network components in the PT-IP network.Identify the hardware and key IP provisioning that enables OAM&P messages to berouted between network components in the PT-IP networkPrerequisite Skills:Register by going to http://www.genband.com/Home/Resources/Training-Course-Registration.aspx.For questions or comments regarding GENBAND Training, email training@genband.com or call 972-461-4134