V900E VER SERIES

...then briefly press the ENC/RADIO button (if the signal led stays on for some seconds and then starts flashing again, theprogramming operation is satisfactorily complete). The data and information reported in this installation manual are susceptible to change at any time and without obligation on CAME cancelli automatici s.p.a. to notify users. Programming the end-stop in the opening phase- Push and keep pressed the OPEN button until the door is fully open... ...then briefly press the ENC/RADIO button (if the signal led stay on the programming operations is satisfactorily complete).Finally, set dip switch n°1 back to OFF. ENGLISHTESTUse the AP/CH button to command both an opening and a closing to verify whether the programmino was successful.15