V900E VER SERIES

More documents

Recommendations

Info

5.5 Preparing the transmission guideThe following applications are only examples, as the space required for unit installation and the accessories varydepending on dimensions and therefore it is up to the installer to select the best solution.ENGLISH1) Fasten the bracket to the tension device on the transmission guide using the supplied bolts and washers. M6 x 202) Position the transmission guide in the following manner:- for sectional doors directly above spring-release coiling shaft (between 20 and 30 mm of the shaft’s axis).N.B.: if the distance between the coiling shaft and the top part of the door is between 300 and 600 mm, use the V122 arm (seetechnical documentation attached);- for overhead doors between 10 and 20 mm from the highest sliding point of the door.N.B.: for pratially-retractable swing out counterweighted garage doors, use the V201 arm (see technical documentation attached).M6V122The data and information reported in this installation manual are susceptible to change at any time and without obligation on CAME cancelli automatici s.p.a. to notify users.V2016
5.6 Fastening the transmission guide1) Fasten the transmission guide to the centre of the doorway using the proper screws.Raise the guide until it is horizontal with the ceiling so as to choose the proper type of fastener.The data and information reported in this installation manual are susceptible to change at any time and without obligation on CAME cancelli automatici s.p.a. to notify users. 2) If the angle brackets are not suffi cient, cut the tension brackets down to the right length and fasten them to the ceiling.N.B.: to strengthen the bar additional angle or tension brackets may be installed.3) Fasten the transmission guide to the ceiling using the proper bolts.M6M6 x 14ENGLISH7
Page 1 and 2: AUTOMATION FOR SECTIONAL ANDOVERHEA
Page 3 and 4: The data and information reported i
Page 5: 5.3 Cable list and minimum thicknes
Page 9 and 10: 5.8 Fastening the gearmotor to the
Page 11 and 12: 6.2 Main componentsThe data and inf
Page 13 and 14: Warning devices The data and i
Page 15 and 16: ...then briefly press the ENC/RADIO
Page 17 and 18: TransmittersTOP SERIESThe data and
Page 19 and 20: T264M - T304MT2622M - T3022MThe dat
Page 21 and 22: 11 Manufacturer’s warrantyMANUFAC

V900E VER SERIES

Create successful ePaper yourself

Delete template?

Save as template?