Welcome to Onyx-RAD - Viztek

Step 11 : “QC” the image(s)When you have completed the scanning and have no moreimages to add to the study, it’s time to perform some qualitycontrol. The study is currently marked “INCOMPLETE,”indicating that the technologist has not yet verified and/orprepared the images.At this time you should open the study (double-click thestudy; see the previous chapter for a brief introduction to theStudy Listing screen and the Image Viewing screen.)View the images and optionally prepare them for the doctorby adjusting the contrast or zooming, etc.When you are satisfied with the images, close the study(right-click on an image, then choose “Close Study”).Back at the Study Listing screen now, you should validatethe study (which changes its status from INCOMPLETE toUNREAD) with the following procedure:1. Click the study one time to select (highlight) it.2. Click the “OK” button to validate the study. Thisbutton is found to the left of the New Patient / Study /Series buttons, and is pictured below.If you wish to delete the study (perhaps the images werereally off, or the wrong body part was scanned?), use thisprocedure:1. Click the study one time to select (highlight) it.2. Click the delete button to validate the study. Thisbutton is found to the left of the New Patient / Study /Series buttons, and is pictured below. (It is a pictureof an eraser.)ValidateDeleteOnyx-RAD is a registered trademark of Viztek, Inc. © 1995-2002 Page 145