12.07.2015 Views

WESTERBEKE GASOLINE GENERATOR

WESTERBEKE GASOLINE GENERATOR

WESTERBEKE GASOLINE GENERATOR

SHOW MORE
SHOW LESS
  • No tags were found...

Create successful ePaper yourself

Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.

ENGINE ADJUSTMENTSNOTE: <strong>WESTERBEKE</strong> recommends that the following engineadjustments be performed by a competent engine mechanic.The information below is provided to assist the mechanic.8. Tum the crankshaft clockwise by nine camshaftsprocket teeth (81") to align the timing mark on thecamshaft sprocket with the tcnsioner set mark on thetiming belt rear cover.A CAUTION: This operation is performed to give aproper tension to the timing belt, so do NOT turn thecrankshaft counterclockwise and push the belt tocheck the tension.9. Make sure that the timing belt teeth are engaged withthe camshaft sprocket teeth along the portion of thesprocket shown by the curved arrow in the illustrationbelow. Then tighten the tcosioner nut.10. Pull the timing belt in the center of the tension sidetoward the sealing gasket line for the belt cover, asi1lustrated. Make sure that the clearance between theback of the belt and the sealing line is the standardvalue.Standard Value: 12mm (0.47in.)SEALINGGASKET/L1NE\\0:1 ~>-__ 12 mm (GA7IN)11. Pull out a rod from the plug hole on the left surface ofthe cylinder block and apply the specified sealant.Then tighten the plug to the specified torque.Specified sealant value: 3M AID Part No. 8660 orequivalentTightening torque: 15-22 Nm (11-16 ft.lbs.)Engines & Generators28

Hooray! Your file is uploaded and ready to be published.

Saved successfully!

Ooh no, something went wrong!