Vig645M Motherboard Manual - Viglen Download

Problems & SuggestionsTable 6: Problems and SuggestionsWhat happens What to doApplication softwareproblemsTry resetting the system.Make sure all cables are installed correctly.Verify that the system board jumpers are set properly.Verify that your system hardware configuration is set correctly. InSetup, check the values against the system settings you recordedpreviously. If an error is evident (wrong type of drive specified, forexample), make the change in Setup and reboot the system. Recordyour change.Make sure the software is properly configured for the system. Refer tothe software documentation for information.Try a different copy of the software to see if the problem is with thecopy you are using.If other software runs correctly on the system, contact the vendor ofthe software that fails.If you check all of the above with no success, try clearing CMOSRAM and reconfiguring the system. Make sure you have your list ofsystem settings available to re-enter, because clearing CMOS RAMsets the options to their default values.Characters onscreenare distortedor incorrectMake sure the brightness and contrast controls are properly adjustedon the monitor.Make sure the video signal cable and power cables are properlyinstalled.Make sure your monitor is compatible with the video mode you haveselected.Characters do notappear on screenMake sure the video display is plugged in and turned on.Check that the brightness and contrast controls are properly adjusted.Check that the video signal cable is properly installed.Make sure a video board is installed, enabled, and the jumpers arepositioned correctly.Reboot the system.V1.0 Vig645M Motherboard Manual 34