Sound & Parameter List - Roland

Patch editing parametersParameter Value DescriptionPitch Depth-63– +63 Depth to which the LFO will affect the WG pitch(LFO Pitch Depth)Filter Depth-63– +63 Depth to which the LFO will affect the filter cutoff frequency(LFO Filter Depth)Amp Depth-63– +63 Depth to which the LFO will affect the amp level(LFO Amp Depth)Pan Depth(LFO Pan Depth)-63– +63 Depth to which the LFO will affect the amp pan* If the Waveform is “XSIN,” it may be difficult to notice the effect.note:fig.(Sixty-fourth-note triplet), (Sixty-fourth note), (Thirty-second-note triplet), (Thirty-second note), (Sixteenth-note triplet), (Dotted thirty-second note),(Sixteenth note), (Eighth-note triplet), (Dotted sixteenth note), (Eighth note), (Quarter-note triplet), (Dotted eighth note), (Quarter note), (Half-note triplet),(Dotted quarter note), (Half note), (Whole-note triplet), (Dotted half note), (Whole note), (Double-note triplet), (Dotted whole note), (Double note)Solo/Porta (Portamento)These settings specify how the sound is to respond to your playing technique.Parameter Value DescriptionMono/PolyMONO,POLYSpecifies how notes will be producedMONO: Only one note at a time will sound.POLY: More than one note can be played simultaneously.It is effective to use the MONO setting when playing a patch of a single-note instrument such as saxor flute.Legato Switch OFF, ON Specifies whether legato will be used (ON) or not (OFF)Legato is a function that is available when the Mono/Poly parameter is set to MONO. When Legatois turned ON, pressing another pad while the previously played pad is still held down will cause thepitch to change to the newly played pad, while the note continues to sound. This can be used to simulatethe hammering-on/pulling-off performance techniques used by a guitarist.Legato Retrigger OFF, ON Selects whether the note will be retriggered when using Legato.Normally, you will leave this “ON.” If this parameter is turned “OFF,” pressing another pad whilethe previously played pad is still held down will cause only the pitch to change, which may cause anunnatural-sounding result for some waveforms. It is best to turn this “OFF” when playing wind orbowed-string instrument sounds, or when simulating a monophonic synthesizer.* This setting is ignored if the Legato Switch is “OFF.”PORTAMENTOPortamento is a function that causes the pitch to change smoothly from one note to the next note played. When the Mono/Poly is set to MONO,this can be effective in simulating performance techniques such as a violinist’s glissando.Portamento Switch OFF, ON Portamento on/offPorta Mode(Portamento Mode)Portamento TypeNORMAL,LEGATORATE,TIMEMethod of play for which the portamento effect will be appliedNORMAL: Portamento will always be applied.LEGATO: Portamento will be applied only when you play legato (i.e., press the next pad before releasingthe previous pad).How the difference in pitch between the notes you play will affect the time over which the pitch changeoccursRATE: The time over which the pitch changes will be proportionate to the difference in pitch betweenthe two notes.TIME: The pitch change will occur over a fixed time, regardless of the difference in pitch between thetwo notes.52