Pro 200 Series Furnace - Whip Mix

Pro 200 Series Furnace Operations ManualWarningsDO NOT OPERATE THIS FURNACE WITH ANY OTHERPOWER CORD.DO NOT OPERATE WITH AN EXTENSION CORD.OPERATING THIS FURNACE ON A CIRCUIT WITH OTHERFURNACES OR ELECTRICAL APPLIANCES THAT REQUIRESIGNIFICANT POWER MAY CAUSE A CIRCUIT BREAKERTO TRIP.When operating the Pro 200, USE ONLY ARGON GAS.ATTACHING ANY FLAMMABLE OR NOXIOUS GAS IN THISFURNACE COULD CAUSE EXPLOSION OR PERSONALINJURY!CAUTION: METAL SURFACE IS HOT DURING OPERATION!The triangular black and yellow sticker on thefront center of the muffle hood is a warningTHAT the metallic surface can become hot to thetouch. Never place your hand on this surfaceor lean on the top of the hood when the unit isin operation.IMPORTANT: Contact your dealer or the factoryfor complete instructions on converting thefurnace between 115 VAC and 220 VAC.Hazardous live voltage present; disconnect ACMain Power cord before removing covers.WarrantyUnited States and CanadaWhip Mix Corporation warrants the Pro 200 and Pro Press200 to the original purchaser against defective workmanshipand materials under normal procedures of installation, useand service within the dental profession, for a period ofthree years or 3750 muffle hours, whichever occurs first.During which time Whip Mix Corporation will replace, repairor deny warranty coverage at its discretion. Heat treatingrefractory materials, misuse, improper installation, impropermaintenance, accident or abuse will void the warranty. WhipMix coverage only applies to Whip Mix supplied parts, andrepairs performed by Whip Mix certified repair technicians.Repairs performed during the warranty period do not extendthe warranty period. Shipping damage is only covered fromWhip Mix to the intended recipient.RecommendationsNote: During shipping the muffle might absorb moisturefrom the air. So, it is recommended you heat the muffleto dry the moisture before firing any porcelain. To dry themuffle, set the idle temperature to 400° C (752° F) for onehour and 600° C (1112° F) for one hour.Follow the numbered instructions in this section to set theidle temperature to the temperatures mentioned above.Whip Mix recommends leaving the furnace on at all times.Turning the furnace off overnight may cause damage tothe muffle, contamination and void the warranty.Leaving your furnace on will also extend the life of yourfurnace. See Night Mode, page 11 for further information.InternationalTwo years parts and labor from date of purchase from dealer.The Pro Series Furnace comescomplete with:Pro Press 200 Pro 200ManualManualCooling TrayCooling TrayFiring TrayFiring TrayPress Firing TrayPower CordPower CordTemperature Calibration CertificateTemperature Calibration Certificate Flash DriveCeramic InsertQuick Start Guide & DVDPress Air RegulatorWarranty Registration CardFlash DriveTip sheetQuick Start Guide & DVDProgram MagnetWarranty Registration CardQuick Cool Barb and HoseTip SheetMaster Suite DVDProgram MagnetQuick Cool Barb & HoseMaster Suite DVDIntended Use:The Pro 200 furnace is only intended for the firing ofdental porcelain materials or the pneumatic pressingof molten porcelain materials into lost wax investmentmolds. If this furnace is not used in a manner specified bythe Whip Mix Corporation, the protection provided by theproduct might be impaired.217280 Pro Series 200 Manual_ENG.indd 2 8/12/11 1:54 PM