Pro 200 Series Furnace - Whip Mix

More documents

Recommendations

Info

Pro 200 Series Furnace Operations ManualExternal Component LocatorTop Muffle CoverPressRegulatorAttachmentLift TableCalibration PortSelector KnobKeyboardBack CoverQuick Cool JetHose BarbPower SwitchPower Inlet PlugVacuum PumpPower OutletUSB PortFusesVacuum PumpHose BarbArgon Hose Barb417280 Pro Series 200 Manual_ENG.indd 4 8/12/11 1:54 PM
Pro 200 Series Furnace Operations ManualChapter One — Getting StartedYou are undoubtedly eager to unpack, set up, and begin using your new furnace. Getting started will be much easier if youcarefully review the information in this chapter and follow the steps as outlined.Before Unpacking• Save the carton and packing materials. These will be usedagain if there is ever a need to ship or return equipment.• Read and save the printed shipping material packedwith your furnace — it contains valuable information!• DO NOT turn on the power to your furnace untilyou are instructed to do so, or you will damageyour furnace!• Sit the furnace on a non-flammable work surface.Unpacking• If the packaging materials and/or the furnace appear tobe damaged, please call your dealer before continuing.• Remove the furnace from the packing materials andplace it on a flat surface in the upright position.• Look up into the muffle area and locate the shippinghardware and remove it. Keep these parts in casethere is a need to ship the furnace back.Press Version• Connect the compressed air supply to the regulatorusing a standard pneumatic fitting available at mosthardware stores.• Adjust the pressure regulator to the recommendedpressure from the ceramic manufacturer.If problems arise:• Check the air supply for sufficient pressure.• Check all connections. If problems persist, writedown your serial number and call Technical Support.Press Regulator Set-UpThe Pro Press 200 requires compressed air to run a presscycle. Generally minimum air pressure of 63 psi/4.25BAR and a maximum of 150 psi/10 BAR. Check with theceramic manufacturer.Inputting more pressure could causean explosion!• Remove the regulatorfrom the accessorybox.• Look at the femaleend of the brass quickconnect and checkfor obstructions orforeign objects.• With the clear plastic portionfacing down, push the regulatoronto the quick connect fitting atthe back of the furnace, as shown.Make sure the quick connect isfastened.• Connect the compressed air supply to the regulatorusing a standard pneumatic fitting.If problems arise:• Check the air supply for sufficient pressure.• Check all connections.If problems persist, write down your serial numberand call Technical Support.Installing the Vacuum PumpIf you have a Whip Mix vacuum pump, plug it directly intothe furnace where indicated on the back. If the pump isnot a Whip Mix pump, you will need an adaptor.• Attach a 1/4" inch vacuum rated hose fromthe vacuum pump to the brass fitting markedVACUUM PUMP at the rear of the furnace.DO NOT attach the Argon gas system to the Pro 200until the furnace is installed, operating, and the setupprocedures in the Special Functions chapter of thismanual have been completed.517280 Pro Series 200 Manual_ENG.indd 5 8/12/11 1:54 PM
Page 1 and 2: Pro 200 Series FurnaceOperators Man
Page 3: Pro 200 Series Furnace Operations M
Page 7 and 8: Pro 200 Series Furnace Operations M

Pro 200 Series Furnace - Whip Mix

Create successful ePaper yourself

Delete template?

Save as template?