Pro 200 Series Furnace - Whip Mix

Pro 200 Series Furnace Operations ManualQuick-Cool Jet Installation forPro 200 Furnaces with Air Cool JetPreparation:1. Remove the vacuum pump from its box.2. Remove the brass hose barb from the Furnaceaccessory box.3. Remove the muffler from the output end of thevacuum pump. (The input and output valves areidentified by arrow indicators on the vacuum pumpnear inlet or outlet.)4. Install the brass barb to output end of the vacuumpump. (Where the muffler used to be.)5. There should be two hoses included. One in theaccessory box, the other inside the vacuum pumpbox. Use the hose included in the accessory box forthe Quick-Cool Air Jet.This side goes to theQuick Cool JetInstallation:1. Push one end of the clear hose included in theaccessory box over the output barb fitting at theoutput end of the vacuum pump.2. Place the other end over the silver Quick-Cool Jetbarb located on the upper right back of the furnace.(See below.)3. Using the other pink hose, place one end over theinput side barb of the vacuum pump.4. Place the other end over the vacuum barb at the backof the furnace.5. Plug the power cord into the power outlet at the backof the furnace next to the furnace power inlet.Quick-CoolJet BarbMain PowerInletVacuum PumpPower OutletVacuumHoseBarbUsing the Quick-Cool Jet:The Quick-Cool Jet will activate when a program has beenstarted with a lower entry temperature than the furnace'scurrent temperature.1. To enable the Quick-Cool Jet, select and run aprogram with an entry temperature lower than thecurrent temperature.2. Once a program is complete, start the next programand the Quick-Cool Jet will engage.Output Barbgoes hereInputBarb617280 Pro Series 200 Manual_ENG.indd 6 8/12/11 1:54 PM