EAGLE CORR PE™ * - JM Eagle

Gasket label should be upright andreadable from cut end of pipeField cut end of pipeClean corrugation valleybefore placing gasket on pipeFigure 18Note: Gasket shown for illustrative purposes. Actual gasket size and shapemay vary.To assemble Eagle Corr PE use only the JM Eagle approved lubricantsupplied, based on normal conditions. Extra lubricant needed for adverseconditions must be ordered separately. Lubricant is supplied for pipe andfittings based on the number of spigot ends involved.3.3.1 Lubricant RequirementsThe following table gives the number of pipe joints that can be assembledusing a 1-quart container of lubricant for Eagle Corr PE pipe. See Table 3.28 EAGLE CORR PE INSTALLATION GUIDE