EAGLE CORR PE™ * - JM Eagle

• Excavate an area along the length of the pipe sufficient to remove thedamaged section of pipe plus exposing 3 feet of each end of the piperemaining in the ground.• Excavate a trench width sufficient to compact around the pipe to bereplaced and to place necessary trench safety equipment.• Cut out and remove the damaged section of pipe. Take care to cut thepipe between the corrugations.• Prepare the bedding for pipe as described previously in this manual.• Place PVC repair sleeves on each section of the pipe to remain inthe ground.• Place valley gaskets on each end of pipe to remain in the ground.• Place valley gaskets on each end of the new section of pipe.• Place the new section of pipe in the trench. (See Figure 36 below.)• Slide PVC repair sleeves so that they cover gaskets. Be sure andlubricate gaskets as required.• Carefully replace initial backfill to provide proper support.Valley gasket(typical)Replacement pipe(length varies)Pipe remainingin trenchSlide sleevesinto placePVC repair sleeve(typical)Replacementlength(varies)Figure 36Seal-Tite Couplers Option B – Seal-Tite CouplerEAGLE CORR PE INSTALLATION GUIDE67