Rider's Manual K 1200 S - K100.biz

z MaintenanceFront-wheel standUseA front-wheel stand for simple,safe changing of the front wheelis available from BMW Motorrad.The BMW special tool numberis 36 3 971 and the front-wheelstand is available from your authorisedBMW Motorrad dealer.You also need the adapters withthe BMW special tool number36 3 973.Installing front-wheelstandPlace the motorcycle on anauxiliary stand; BMW Motorradrecommends the BMW Motorradrear-wheel stand.with OA Centre stand:Make sure the ground is leveland firm and place the motorcycleon its centre stand.Use locating pins 3 to set thefront-wheel stand to the desiredheight.Centre the front-wheel standrelative to the front wheel andpush it against the front axle.8113The BMW Motorrad frontwheel stand is not designedto support motorcycles not fittedwith a centre stand or withoutother auxiliary stands. A motorcycleresting only on the frontwheel stand and the rear wheelcan topple.Place the motorcycle on itscentre stand or another auxiliarystand before lifting the frontwheel with the BMW Motorradfront-wheel stand.Slacken adjusting screws 1.Push the two pins 2 apart untilthe front suspension fitsbetween them.Push both mounting pins 2through the triangles of thebrake caliper anchorages justfar enough to allow the frontwheel to be rolled betweenthem.There is a risk of damagingthe ABS sensor ring of theBMW ABS.Push the pin in just far enough to