ACCON-S7-EasyLog User Manual - INEE

More documents

Recommendations

Info

ACCON-AGLink 4.0 configuration4.3 S7-NetLink-PROFigure 13: S7-NetLink-PROThe group »Local connection« contains parameters of the ACCON-NetLink-PRO.The IP address of the ACCON-NetLink-PRO has to be put in the field »NetLink IPaddress«.The group »Station parameter« contains the station-related parameter of theACCON-NetLink-PRO. The switch »Automatic reconnaissance of the net-relatedparameters« means that the bus parameters transferred to the ACCON-NetLink-PRO are not used if the ACCON-NetLink-PRO is able to detect the bus parametersitself. This affects the settings for »Address«, »Transmission rate«, »Highest nodeaddress« and »Profile«. Under »PG-Address« the address is given to thePROFIBUS card. The address must be in the range of 0 up to the value adjustedunder »Highest node address« being put. Addresses have to be unique within onePROFIBUS.The parameter »Timeout« sets the connection timeout. The value is indicated inmilliseconds. The value can be increased when having problems, e.g. with highresponse times in the PROFIBUS.The group »Network parameter« contains the net-related attitudes of the ACCON-NetLink-PRO. With »Transmission rate« the speed used at the PROFIBUS isadjusted. The value at »Highest node address« sets the highest available addressat the PROFIBUS. It must be guaranteed that all participants have the same highestnode address. With »Profile« the parameter for the PROFIBUS will be set. Theseare profile specific time parameters.The group »Connection parameter« contains settings of the attached adapterregarding connections be built on. The »Connection type« sets the type ofconnections to be built on. The adjusted value doesn't have influence on thecommunication possibilities.ACCON-S7-EasyLog 18 DELTALOGIC GmbH
ACCON-AGLink 4.0 configurationBy pressing »Configure NetLink…« the program tries to reach and parametrize theconnected ACCON-NetLink. Using the button »Scan NetLinks…« all connectedACCON-NetLinks are shown in a separate window can be parametrized there, too.ACCON-S7-EasyLog 19 DELTALOGIC GmbH
Page 1 and 2: ACCON-S7-EasyLogUser ManualVersion
Page 3 and 4: Table of contents1 Table of content
Page 5 and 6: Main view2.1 Starting parameters of
Page 7 and 8: ACCON-AGLink 4.0 configuration3.2 B
Page 9 and 10: ACCON-AGLink 4.0 configurationFigur
Page 11 and 12: ACCON-AGLink 4.0 configurationS7 da
Page 15 and 16: ACCON-AGLink 4.0 configurationadjus
Page 17: ACCON-AGLink 4.0 configurationThe g
Page 21 and 22: ACCON-AGLink 4.0 configurationThe
Page 27: Installation5 Installation• Inser

ACCON-S7-EasyLog User Manual - INEE

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?