ACCON-S7-EasyLog User Manual - INEE

More documents

Recommendations

Info

ACCON-AGLink 4.0 configuration4.6 S7-PC/CPFigure 17: S7-PC/CPThe group »Local connection« contains the Access Point of the Application whichshould be used. The current selected communication device (CPxxxx) is additionallyshown. You can only select allowed and configured access points. Any change onthis, e.g. adding a new access point, changing the configuration or setup thecommunication devices, are done in the applet »Set PG/PC Interface« in the controlpanel.The group »Station parameter« contains the local settings. The parameter»Timeout« sets the connection timeout. The value is indicated in milliseconds. Thevalue can be increased when you have problems e.g. with high response times atthe PROFIBUS.The group »Connection parameter« contains settings regarding connections be builton. The »Connection type« sets the type of connections to be built on. The adjustedvalue doesn't have influence on the communication possibilities.ACCON-S7-EasyLog 24 DELTALOGIC GmbH
ACCON-AGLink 4.0 configurationFigure 18: ACCON-AGLink 4.0 connection testGoing to the tab »Test« you can check if the connected device works correctly. If thecommunication settings are correct, the MLFB numbers of the reachable CPUswhich are adjusted via the device are shown.ACCON-S7-EasyLog 25 DELTALOGIC GmbH
Page 1 and 2: ACCON-S7-EasyLogUser ManualVersion
Page 3 and 4: Table of contents1 Table of content
Page 5 and 6: Main view2.1 Starting parameters of
Page 7 and 8: ACCON-AGLink 4.0 configuration3.2 B
Page 9 and 10: ACCON-AGLink 4.0 configurationFigur
Page 11 and 12: ACCON-AGLink 4.0 configurationS7 da
Page 13 and 14: ACCON-AGLink 4.0 configurationFigur
Page 15 and 16: ACCON-AGLink 4.0 configurationadjus
Page 17 and 18: ACCON-AGLink 4.0 configurationThe g
Page 19 and 20: ACCON-AGLink 4.0 configurationBy pr
Page 21 and 22: ACCON-AGLink 4.0 configurationThe
Page 23: ACCON-AGLink 4.0 configurationFigur
Page 27: Installation5 Installation• Inser

ACCON-S7-EasyLog User Manual - INEE

Create successful ePaper yourself

Delete template?

Save as template?