Compool to EasyTouch Upgrade Manual Rev B 03-15-2010 - Pentair

18Lights MenuFrom the Lights screen you can manually switch all lights on or off, and synchronize colored lights. Up toeight (8) lights can be independently controlled from the Lights screen. Each light requires a separateauxiliary relay circuit. Up to four lights can be assigned on each auxiliary circuit. A circuit name must beassigned to the AUX relay circuits which controls the light. Verify that IntelliBrite, SAm and/or SAL, and/orFIBERworks have been selected in Circuit Function. If FIBERworks lighting is being used, it also has to beset up as a Photon Generator ® light source (PHOTON GENERATOR) for the circuit controlling the light bulb,and COLOR WHEEL for the circuit controlling the color wheel. For more information about setting up lights,see “Settings Menu: Circuit Function,” on page 39.The Color Swim and Color Set Lighting FeaturesGetting There▲MENU LIGHTS LIGHTS▲ModesColorsAll OnAll OffHoldRecallColor SwimColor SetThe Color Swim and Color Set lighting features is selected from the LIGHTS > MODES and (COLORS)menu. At least two (2) Pentair Water Pool and Spa ® , IntelliBrite ® , SAm ® , SAL ® , and/or FIBERworks ® lightingsystems are required to use the lighting features.• Color Swim - Select the Color Swim feature in the MODES and COLORS menus to start lights totransition through colors in sequence to give the appearance of colors dancing through the water. Youcan adjust the delay of each light to make the colors move at different speeds using the LIGHTS >CONFIG option. This lighting feature requires a separate relay for each light. To switch off the ColorSwim feature, select the AUX button assigned to the light circuit or select ALL OFF in the Lightsmenu.• Color Set - Select the Color Set feature in the MODES and COLORS menus to switch the light onusing specific color as selected in the COLORS menu. This feature requires a separate relay foreach light. To switch off the Color Swim feature, select the AUX button assigned to the light circuitor select ALL OFF in the Lights menu.• Configure - Select “Configure” to setup the positions of the lights the pool. Up to eight (8) lights canbe assigned a position. For more information see page 22.All On 1- [NONE ]1- [AUX 1 ]All Off2- [NONE ] 2- [LT.GREEN ]Sync3- [NONE ] 3- [1ST POSITION ]Configure 4- [NONE ] 4. [DELAY 5 SECS]• Sync - Select the Sync feature in the LIGHTS menu to switch on all IntelliBrite, SAm, SAL, orFIBERworks color changing lights and synchronize their colors.• Smart Start (SS: Yes/No) - Select Smart Start in the Schedules menu (see page 27). The Smart Startfeature automatically starts changing colors when the lights are programmed to switch on. SmartStart is used when Color Swim and IntelliBrite show modes are being used.Compool/EasyTouch Pool and Spa Control System Upgrade Installation and User’s Guide